Product ID:RED COMPOUND EXTRA FAST CUT, DRX45
MSDS Date:08/09/1990
FSC:8010
NIIN:00N027628
MSDS Number: BMTKQ

PPG INDUSTRIES INC (WAS PTTTSBURGH PLATE GLASS CO)

ONE PPG PLACE
PITTSBURGH, PA 15272-0001
US

Emergency Phone: 412-434-3131

Info Phone: 412-434-3131

Cage: 47695

PPG INDUSTRIES INC

PITTSBURGH, PA 15272 US

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 10-15%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293

SILICA, CRYSTALLINE - CRISTOBALITE

CAS: 14464-46-1

RTECS: VV7325000

Fraction By Weight: 35-40%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.05 MG/M3 RDUST9293

ANIMALS. LONG-TERM EXPOSURES TO CRYSTALLINE

RTECS: 9999999ZZ

SILICOSIS. THESE EFTS ARE ASSOCD W/BRTHG EXCESSIVE

RTECS: 9999999ZZ

TO GENERATE EXCESSIVE AMTS OF RESPIRABLE SILICA, SO

RTECS: 9999999ZZ

HAVE MATL SAFETY DATA SHEET INFORMATION

RTECS: 9999999ZZ

MATERIAL *PERSISTENT SKIN/EYE IRRITATION OR

RTECS: 9999999ZZ

FREE FALL OF LIQUIDS IN EXCESS OF A FEW INCHES.

RTECS: 9999999ZZ

EXPOS LIMS, THE LEL BELOW THE STATED LIMIT, & TO

RTECS: 9999999ZZ

COATED WITH THIS PROD.

RTECS: 9999999ZZ

SILICONE OXIDE; (SILICA, AMORPHOUS-DIATOMACEOUS EARTH)

CAS: 68855-54-9

Fraction By Weight: 55-60%

OSHA PEL 10 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

KEROSINE (HYDRODESULFURIZED)

Fraction By Weight: 30-35%

FILM FORMERS, RESINS, AND ADDITIVES

Fraction By Weight: 10-15%

THE FOLLOWING HAZARDOUS MATERIALS ARE COMPONENTS OF ONE OR

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INGEST:HARMFUL/FATAL. EYE:
CAUSES SEV IRRIT. SKIN: CAUSES PRIMARY IRRIT. MAY BE ABSORBED THRU
SKIN. INHAL:VAPOR & SPRAY MIST MAY BE HARMFUL. SANDING & GRINDING
DUSTS MAY BE HARMFUL IF INHALED.CH RONIC:AVOID LONG TERM & REPEATED
CONTACT. THIS PROD CONTAINS A FORM OF CRYSTALLINE SILICA WHICH IARC
(SUPP DATA)
Explanation of Carcinogenicity:CRYSTALLINE SILICA QUARTZ: GROUP 2A
(IARC);GROUP 2 (NTP)
Effects of Overexposure:REDNESS, ITCHING, BURNING SENSATION & VISUAL
DISTURBANCES MAY INDICATE EXCESSIVE EYE CONTACT. DRYNESS, ITCHING,
CRACKING, BURNING, REDNESS & SWELLING ARE CONDITIONS ASSOCIATED
WITH EXCESSIVE SKIN CONT ACT.

First Aid:INGEST:DO NOT INDUCE VOMIT. EYE:FLUSH IMMED W/PLENTY OF WATER
FOR AT LEAST 15 MIN. SKIN:REMOVE PROMPTLY BY WIPING, FOLLOWED BY
WATERLESS HAND CLEANER & SOAP & WATER. INHAL:IF AFTD BY INHAL OF
VAP/SPRA Y MIST, REMOVE TO FRESH AIR.APPLY ARTF RESP & OTHER
SUPPORTIVE MEASURES AS REQD.OTHER:IF ANY OF THE FOLLOWING OCCUR
DURING/FOLLOWING USE OF PROD, CONT A POIS CNTL CNTR, EMER ROOM/MD
IMMED. (ING 10)

Flash Point Method:PMCC
Flash Point:195F,91C
Lower Limits:0.6%
Extinguishing Media:USE NFPA CLASS B EXTING (CO*2/DRY CHEM/UNIVERSAL AQ
FILM FORMING FOAM) DESIGNED TO EXTING NFPA CLASS 111A (SUPP DATA)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS (SUPP DATA)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT/ELEC EQUIP/SPKS & OPEN FLAMES. CLSD CNTNRS MAY EXPLODE WHEN
EXPOS TO EXTREME HEAT. DO NOT APPLY ON HOT (SUPP DATA)

Spill Release Procedures:PROVIDE MAXIMUM VENT. ONLY PERS EQUIPPED
W/PROPER RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE
ALL SOURCES OF INGNITION. TAKE UP SPILLED MATERIAL WITH SAWDUST.
VERMICULITE, OR OTHER ABSO RBENT MATERIAL AND PLACE INTO CNTNRS FOR
DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE >120F. STORE LG
QUANTITIES IN BUILDINGS DESIGNED & PROTECTED FOR STORAGE OF NFPA
CLASS IIIA COMBUST LIQS.
Other Precautions:IF MATL IS PART OF A MULTIPLE COMPONENT COATING SYS,
READ MATL SAFETY DATA SHEET(S) FOR OTHER COMPONENT(S) BEFORE
BLENDING AS THE RESULTING MIX MAY HAVE HAZARDS OF ALL OF ITS PARTS.
CNTNRS SHOULD BE G ROUNDED WHEN POURING. AVOID (ING 12)

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A SUITABLE
NIOSH/MSHA APPROVED RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION/LOCAL EXHST VENT IN VOL & PATTERN TO
KEEP CONC OF INGS LISTED BELOW LOWEST SUGGESTED (ING 13)
Protective Gloves:NITRILE/NEOPRENE RUB/POLYVINYL ALCOHOL.
Eye Protection:CHEM WORK GOG/FULL LGTH FSHLD .
Other Protective Equipment:WEAR PROTECTIVE CLOTHING, INCLUDING
IMPERMEABLE APRON.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXTING MEDIA:COMBUST LIQ FIRES. FIRE FIGHT PROC:BUILD-UP & POSS
AUTOIGNIT/EXPLO WHEN EXPOS TO EXTREME HEAT. IF WATER IS USED, FOG
NOZ ARE PREF. EXPLO HAZ:SURFS. TOX GASES MAY FORM WHEN PROD IS
CONTACT ED BY FLAME/HOT SURFS. HAZ DECOMP PROD:FUMES INCLUDING: CO.
HLTH HAZ:ASSOC W/INCREASED RISK OF CANCER IN LAB (ING 7)

HCC:V4
Boiling Pt:B.P. Text:>340F,>171C
Vapor Pres:0.4
Vapor Density:HVR/AIR
Spec Gravity:1.30
Evaporation Rate & Reference:2 (BUOAC=100)
Solubility in Water:0%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISITC OF THE
SOLVENTS LISTED.
Percent Volatiles by Volume:54

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS, OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZ DECOMP PRODS WHEN
HEATED. WELDING/BRAZING/FLAME-CUTTING ON SURFS COATED W/PROD MAY
PRODUCE (SUPP DATA)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF I/A/W
FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THRU AN APPROVED WASTE MANAGEMENT FA CILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.